MARBOCOTE® W810 is categorized basically under elastomer additives and performance additives. This particular product enhances the properties and performance of elastomers. This product is a valuable component in elastomer formulations. It mainly contributes to the improved material characteristics and functionality of elastomers.

Supplied By: Marbo America Inc

Product Code: Q05667

Regional Availability: Canada

    Enhanced TDS

    Identification & Functionality

    Features & Benefits

    Labeling Claims
    Materials Features
    Product Highlights
    • Easy application
    • Fast curing – minimum down time
    • Non contaminating
    • Safe water based formulation
    • Low odour
    • Minimal mould build-up
    • Reduces need for mould cleaning
    • Durable; provides multiple releases per application
    • Versatile; releases a wide range of rubber types and formulations

    Applications & Uses

    Markets
    Applications
    Segments
    Applications
    Compatible Polymers & Resins
    Plastics & Elastomers End Uses
    Product Applications
    • The mould should be clean and dry before use. If necessary, clean the mould using an abrasive (for example, sand, metal or dry-ice shot-blasting). When possible, this should be followed by wiping the mould with a solvent based cleaner, such as Marbocote Mould Cleaner. Although MARBOCOTE® W810 can be applied over existing semi-permanent release agents, best performance is obtained by removing all traces of prior products. Mould cleaning and release agent application should be performed in a well-ventilated area. Marbocote® W810 can be applied using any spray equipment capable of producing fine atomisation.
    • Best results will be obtained by using the following parameters that are dependent on mould temperature.
    Mould temp (deg C) Gun Output (ml/min) Air Pressure (bar) Number of coats Cure time* (min)
    180 100 5 4 2
    150 80 4 4 4
    120 70 3 5 7
    90 60 2.5 6 12
    60 40 2 8 20
    • No waiting is required between coats (* the cure time is only required after the final coat has been applied). Apply each coat at 90 degrees to the last. Spray the product directly onto the preheated mould surface from a distance of 100 – 200mm. For difficult to reach areas, use a spray gun extension or lance. For new moulds, 2 additional coats are recommended. Do not over-apply.

    Reapplication:
    When release becomes hesitant, reapply one coat of MARBOCOTE® W810 in the same manner as described above.

     

    Properties

    Physical Form
    Appearance
    White liquid
    Odor
    Slight
    Note
    • The polymeric resin used in MARBOCOTE® W810 reacts when heated. Marbocote® W810 is supplied ready to use, no shaking or mixing is required. Please store in original container.
    • MARBOCOTE® W810 is not designed for the release of silicone elastomers.

    Packaging & Availability

    Packaging Type
    Regional Availability
    • Canada

    Storage & Handling

    Shelf Life
    12 Months
    Storage Conditions

    Store below 35°C.