LOCTITE® TW 605

• EMRALON TW-605 has been found to be an effective product in applications requiring squeak suppression and provides freeze-release characteristics when applied on primary door seals and is reducing the friction between rubber and glass or painted surfaces.
• The product contains an UV-tracer to make it visible under UV light ( for checking presence of the coating).
• The cured coating is mat black in appearance, flexible, shows a good wear resistance and is not abrasive to painted surfaces.

Features:

• Waterborne coating
• One Component System
• Excellent water repellence
• Performs over a range of coating thicknesses
• Flexible curing cycles

Benefits:

• Safer handling; environmental friendly
• Ease of use
• Safer handling; reduced health risks
• Economical coating thickness can be selected for each application
• Versatile in many application conditions

• Always use closed containers while stirring (lid with a hole)
• Short stirring for 10 min at 200 rpm
• Reduced stirring speed (ca. 40 - 60 rpm) during usage of Emralon TW 605

Theoretical Coverage:

• ca. 30 m²/kg at 10 μm dry coatings thickness

Application:

• It is designed to be spray applied in-line or off-line to rubber extrusions or molded parts with a surface temperature of 50-120°C

Pre-treatment:

• It has an internal adhesion promoter and it might work without any pre-treatment, but this must be checked by the users, because the adhesion results might vary depending on the different rubber compounds and line conditions.

Recommended coating thickness:

• Squeak suppression:
  • A dry coating thickness of 10 μm is required to obtain proper squeak suppression.
• Freeze release:
  • Good freeze-release properties are already obtained with a dry coating thickness of 10 - 15 μm.

Cure:

• Advised schedule:
  • 20 minutes at 70°C
  • 5 minutes at 100°C
  • 2 minutes at 180°C
• In all cases substrate temperature

Test for cure:

• Toluene wipe test : at least 20 rubs

• Always use closed containers while stirring (lid with a hole)
• Short stirring for 10 min at 200 rpm
• Reduced stirring speed (ca. 40 - 60 rpm) during usage of Emralon TW 605

Theoretical Coverage:

• ca. 30 m²/kg at 10 μm dry coatings thickness

Application:

• It is designed to be spray applied in-line or off-line to rubber extrusions or moulded parts with a surface temperature of 50-120°C

Pre-treatment:

• It has an internal adhesion promoter and it might work without any pre-treatment, but this must be checked by the users, because the adhesion results might vary depending on the different rubber compounds and line conditions.

Recommended coating thickness:

• Squeak suppression:
  • A dry coating thickness of 10 μm is required to obtain proper squeak suppression.
• Freeze release:
  • Good freeze-release properties are already obtained with a dry coating thickness of 10 - 15 μm.

Cure:

• Advised schedule:
  • 20 minutes at 70°C
  • 5 minutes at 100°C
  • 2 minutes at 180°C
• In all cases substrate temperature

Test for cure:

• Toluene wipe test : at least 20 rubs

• Product should be stored at temperatures between 5 and 30°C.
• Return to room temperature before using. Do not freeze.
• 9 months from date of qualification under original seal.