LOCTITE® EA E-30CL™

• Cure - Room temperature cure after mixing
• Application - Potting and Bonding

This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials.

• Use gloves to minimize skin contact. DO NOT use solvents for cleaning hands.
• Dual Cartridges: To use simply insert the cartridge into the application gun and start the plunger into the cylinders using light pressure on the trigger.
• Next, remove the cartridge cap and expel a small amount of adhesive to be sure both sides are flowing evenly and freely.
• If automatic mixing of resin and hardener is desired, attach the mixing nozzle to the end of the cartridge and begin dispensing the adhesive.
• Bulk Containers: Utilize volumetric dispensing system to ensure proper mix ratio and utilize mix nozzle to obtain adequate mixing.
• Allow 24 hours at 22 °C for cure. Heat up to 93°C will speed curing. Maximum chemical resistance is achieved after seven days at 22°C.
• Mixed product is free flowing and self leveling. Potting voids by moving the discharge point from the bottom up will give the best results.
• Keep parts from moving during cure. Parts must be positioned to contain the product inside the potting voids during the cure.
• Excessive uncured adhesive can be cleaned up with ketone type solvents.

Mix Ratio (by volume)

2:1 (Resin : Hardener)